Available equipment per June 2009
Complete Powerplant:
34 MWe, 50Hz, 11KV, direct gas fired, 1993, Boiler + steam turbine (cond). Directly available.
CHP, 33 MWe, 50Hz, 11KV, dual fuel, 1991, 55.000 running hours. Directly available.
Gas Turbines:
Frame 5N package 24,2 MWe, 50Hz, 6,3KV
Frame 5R.
Frame 6B Package, 36 MWe, 50Hz, 11KV
GT13E, 164 MWe, 50Hz, 11KV
Steam Turbines:
2,2 MWE, backpressure, 60bar/480C, bp 3-4,5bar, bleeder 608bar, 22 mt/hr,6,3 KV, 50Hz.
Make Blohm & Voss, built 1994, operational hours 55.000. c/w air cooled condenser, steam pressure reducing valves, controls. excellent condition.
4,5 MWE, backpressure, 34bar/390C, bp 3,5bar/140C, 40mt/hr, 3KV, 50Hz.
Make Franco Tosi / Marelli, built 1975, low operational hours.
7,6 MW, backpressure, 90bar/525C, bp 2,5bar/136C, 40mt/hr,
Make SGP, built 1979, good condition.
c/w Renck Tacke gearbox 9981-1500 rpm. Suitable generators available.
5,1 MW, condensing, 2 stage 44bar/405C, 3,5bar/197C,
Make KKK, Twin CA56, operational hours 26.000.
Last inspection report November 2008. excellent condition.
Boilers HP/LP:
Gas fired, 76bar/500C, 160mt/hr, built 1993, Make Babcock Germany, efficiency 92%, complete installation and documentation. Still installed. Excellent condition.
Matching steam turbine available.
7-10 bar, 20mt/hr, gas fired, lowNox burner, built 1992, Make Backer&Rüb. certificates/ manuals available. c/w pumps, dearator, gassupply equipment, stack. 2 units available.
11 bar, 10mt/hr, hot water, gas fired, 180C, built 1996, Make Loos, certificates/manuals available. c/w pumps, stacks, controls. 3000 and 4000 running hours. 2 units available.
Generators:
10 MWe, 12,5KVA, 50Hx, CosÞ 0,8, 1500 rpm, Make Holec, type DG 150x-0.4, built 1994,
37MWE, 44MVA, 50Hz, p.f. 08, 1500rpm, Make ABB, type GBA1250LD, built 1993,
Transformer:
44MVA, 10,5/154KV, 50Hz, YN05, Make Smit, built 1973
1,6MVA, 10,5/0,4KV, 50Hz, Resintype, Make ABB, Built 1999
All equipment we can dismantle, transport, rebuild and commission upon your request.
Condensate pump
Number: 2x
Type: CPK-GM 80-400
Capacity: 32 m3/h
Increase height: 57 mwk
NPSH required: 1,5 m
Temperature: 100 ºC
Rotational speed: 1450 rpm
Measured power: 11 kW
Driveshaft seal: mechanical seal
Material
Casing: GGG 40.3
Rotors: GG 25
Casket shaft: GG 25
Axle: C 45 N
Protection box: 1.4122
Coupling: Eupex
E-motor
Manufacture: Schorch
Type: KA7 180 M-BB014-155
Power: 18,5 kW
Power supply: 1460 rpm
Port: 380/660 Volt
50 Hz
Cooling: Axis ventilator
Industrial centrifugal ventilator:
Air ventilators:
Number: 2
Type: CMAE 560
Driving: Direct
Fan adjustment: + 5%
Capacity: 1600 Nm3/h
Medium: Air
Temperature at the suction side: 20 ºC
Specific gravity: 1,204 kg/m3
Pressure at the suction side: 1 atmosphere
Total pressure: 4460 Pa
Statistic increase of pressure: 4300 Pa
Absorbed power at working point: 27,0 kW
Idem maximum at the curve: 29,2 kW
Rotational speed of the ventilator: 1470 r.p.m.
Extra accessories: 2 silencers
1x left handed
1x right handed
Flue gas fans:
Number: 2
Type: HAE 4 - 32.5
Driving: Direct driving with coupling
Medium: Flue gas
Suction temperature: ±120 ºC
Remaining information is similar to the 2 air fans.
1x left handed
1x right handed
Information about the Motor:
Motors for these 4 air/flue gas fans are similar to each other.
Installed power: 30 kW
Revs of the ventilator nominal: 1500 r.p.m.
Tension/mains frequency: 380/660 V
50 Hz
Manufacture: Rotor N1
HAE4 - 32.5:
CMAE 560 with silencers:
Internal transport, hoisting and site management
